Petsafe Deluxe Big Dog Remote Trainer Bedienungsanleitung PDF herunterladen (Seite 9)

www.petsafe.net 9

Follow the steps below to ﬁ nd your pet’s Recognition Level:

1. Press the Tone Only Button for 2 to 3 seconds. If your pet reacts to this, you may

use this button for training. If your pet shows no reaction, go to the next step.

2. Starting at Level 1, press the Stimulation Only Button continuously for 2 to 3

seconds.

3. If your pet shows no reaction, go to the next Intensity Level and repeat the process.

4. Repeat each Intensity Level several times before moving to the next level.

5. YOUR PET SHOULD NOT VOCALIZE OR PANIC. IF THIS HAPPENS, GO

BACK TO THE PREVIOUS LEVEL AND REPEAT THE PROCESS.

6. If your pet continues to show no response at Level 10, check the ﬁ t of the Receiver

Collar. If your pet has long or thick hair, replace the Contact Points with the longer

set. Then go back to # 2 and repeat the process. If this still does not yield any results,

your pet’s hair will need to be trimmed around the Contact Points.

If all of these steps have been done and your pet continues to show no reaction to the

stimulation, contact the Customer Care Center at 1-800-732-2677.

_____________________________________________________________

Understanding the Remote Transmitter

To train using the Tone Only Button:

The audible sound emitted by the Receiver Collar can be just as effective as the

stimulation for some dogs. The Transmitter Indicator Light will glow for as long as this

button is pressed. To use this button for training, simply substitute “Tone Only Button”

whenever “Stimulation Only Button” is used in the Training Guide section.

To train using the Stimulation Only Button:

You control the timing of the stimulation being applied to your pet. The stimulation

stays on as long as the Stimulation Only Button is pressed. If this button is pressed

longer than 8 seconds, the Remote Transmitter will “time-out,” the Transmitter

Indicator Light will turn off, and stimulation will no longer be delivered to your pet.

This is a safety feature in the Remote Transmitter. If the Remote Transmitter times out,

release the Stimulation Only Button and press it again to deliver stimulation.

Note: For either one or both of these training methods to be effective, they must be used

consistently along with the command you are trying to teach your pet.

0224B_03_400-721-11.indd 90224B_03_400-721-11.indd 9 26/2/05 2:18:45 am26/2/05 2:18:45 am

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

Petsafe Deluxe Big Dog Remote Trainer Bedienungsanleitung Seite 9